Brey-Krause Strut Brace Installation - 944
Author: Skip
Installation :
Open hood to gain access to the strut bearing mounting nuts.
There are (4) 13mm. strut bearing mounting nuts per side. Remove the (2) front and (1) inner |
KLA Strut Brace Installation - 924S, 944, 968
944 STRUT BRACE INSTALL
1) Remove 4 nuts holding strut
assembly to the body.
2) Place bracket over studs with
bracket upright toward front of car.
|
Koni Strut Conversion - 8641-1414S for late 944, 968
Author: Skip
Koni sealed strut insert conversion (8641-1414S)
Description
Image
Parts : Koni 8641-1414S Sport Struts - all conversion and instructions parts included.
|
KLA Strut Brace Installation - 911
Author: Skip
Installation :
Remove front strut bolt and rear inner strut bolt.
Place bracket, long leg of bracket toward front of car, over holes and replace bolts.
Tighten to about |
Koni Strut Conversion - 8641-1414S
Koni Strut Conversion - 8641-1414S This procedure applies to the following Porsche models: 1987-89 944 1987-88 944S 1989-91 944S2 1986-88 944 Turbo 1992-95 968 |
KLA Strut Brace Installation - 964/993
Author: Skip KLA Strut Brace for 964/993 Installation: Remove 3 nuts holding strut assembly to the body. 2 nuts toward front of car. 1 rear/inner nut. Place bracket over studs with |
KLA Strut Brace Installation - 968/944 S2/944 S
1) Remove 4 nuts holding strut
assembly to the body.
2) Place bracket over studs with
bracket upright toward rear of car.
3) Replace washers
and nuts.& |
Ask Dr. Koni
Author: Skip
Question: What's the difference between the red Koni and the Sport Yellow Koni?
Answer: The valving is different. Sport Yellow units have stiffer valving than their St |
Front Shock Replacement
Author: Skip
The 911, 914 and some 944’s featured a rebuildable front McPherson Strut. Instead of having to replace the entire strut unit, you will be able to merely replace the strut insert tha |
What is the Largest Wheel and Tire Combination I can get under my stock 914 fenders?
Author: Skip
One of the most commonly asked questions is, “ How much tire can I get under these fenders?” Well the 914 is not the most exact car ever built, and wheel well space varies a lot from |
Adjustable Ride Height Kit - Paragon
Items Included:
2x - Upper Spring Perch
2x - Koni Competition Bump Rubber
2x - Suspension Spring
2x - Aluminum Threaded Collar
2x - Lower Spring Perch
2x - O-ring |
Brakes, front - 924S, 944, 944S
Author: Skip
Parts:
Rotors - Sebro Slotted ( OE Zimmerman or , gas-slotted and cross-drilled also available)
Pads - ( 944.351.951.02 E Pagid or Jurid , Mintex and KFP Magnum also av |
Camber Plate Installation (Paragon)
Author: Skip
Your new Racers Edge Camber Plates will bolt in without modification.
After jacking up your car and supporting it on jack stands, remove the wheel/t |
Clutch Replacement - Part One
Author: Skip
The following account explains in detail the procedure of changing a clutch in a 944/951. It also contains a list of tools, chemicals, parts and the sources where to find them. The |
Clutch Replacement - Part Two
Author: Skip
TRANSMISSION:
Remove shift boot lever (retaining clip at top )(Be careful of plastic cosmetic items, remove ashtray, two screws, lift center piece slightly & push out lea |
Control Arm Bushing Upgrade - Weltmeister
Author: Skip
Weltmeister has produced several aftermarket solutions to Porsche suspensions for many years. This bushing kit is a replacement for the original equipment rubb |
Porsche Option Codes
Author: Skip
Code
Description
009
3 speed sportomatic transmission
018
Sport steering wheel with elevated hub
020
Speedometer with 2 scales KP |
Rod Bearing Replacement
Discussion:
This procedure will detail the steps necessary to replace the Rod Bearings on a 944 Turbo car. With some modifications it may also be applied to normally aspirated 944 |
Front Shock Replacement (65-89)
Author: Skip The 911, 914 and some 944’s featured a rebuildable front McPherson Strut. Instead of having to replace the entire strut unit, you will be able to merely replace the strut insert th |
KONI Improved Rebate
KONI Improved Rebate Get a $30 to $70 rebate with the purchase of a set of four KONI Street Automotive & Light Truck/SUV shock absorbers or one suspension kit from March 1, 2018 — May 31, 2018. How T |
