Brey Krause Deep Sump Oil Pan Spacer Kit for
Porsche 996, Boxster, Boxster S
Please follow our link for more information and purchasing the R-9095 Deep Sump Oil Pan Spacer Kit
|
Adjustable Ride Height Kit - Paragon
Items Included:
2x - Upper Spring Perch
2x - Koni Competition Bump Rubber
2x - Suspension Spring
2x - Aluminum Threaded Collar
2x - Lower Spring Perch
2x - O-ring |
Camber Plate Installation (Paragon)
Author: Skip
Your new Racers Edge Camber Plates will bolt in without modification.
After jacking up your car and supporting it on jack stands, remove the wheel/t |
Clutch Replacement - Part One
Author: Skip
The following account explains in detail the procedure of changing a clutch in a 944/951. It also contains a list of tools, chemicals, parts and the sources where to find them. The |
Clutch Slave Bleeder Valve Remote
Author: Skip
A couple of years ago, while running at NHIS, I had some difficulty getting good, clean downshifts into second gear without double clutching. While some would attribute this to poo |
KLA Boxster Top Fix
Author: Skip
Boxster Lift Rod End Replacement Instructions:
Raise the tonneau cover to an upright position. This will be just before the top starts to pull back.
|
Dash Replacement
Introduction
Replacing the dash on a late model, 85.5 and newer Porsche 944, is not a difficult task. It is very time consuming and meticulous. Patience is necessary. An ex |
Rear Wheel Bearing Replacement - late 944, 968
Discussion :
This procedure will describe the removal and subsequent installation of rear wheel bearings on a Porsche 944 with aluminum trailing arms (1985.5 & later) |
Rod Bearing Replacement
Discussion:
This procedure will detail the steps necessary to replace the Rod Bearings on a 944 Turbo car. With some modifications it may also be applied to normally aspirated 944 |
Shift Lever Rebuild
This is an alternate procedure This article is an alternate procedure for overhauling the shift lever. Normally, replacement of parts with new would be ideal. The parts ne |
Torque Tube Rebuild
To recondition a Torque tube:
Order 4 of 6006ZB C4 Bearings, they are an odd size and can be hard to locate (at least in New Zealand) so get them first.
Remove the Torque tube from |
Transaxle Replacement
Removal :
You will need to place the car up on jack stands at least 20”. Make sure that it is secure! Remove the rear wheels and the axles. If you have never had the axles |
