No need to sweat the details when your Porsche 944 is equipped with our Denso re-manufactured Air Conditioning Compressor! No core charge and this compressor does come with the clutch installed.

Fits
- Porsche 924S 1986-1988
- Porsche 944 1985.5-1989
- Porsche 944S/944S2/944 Turbo/968 All

• 

WARRANTY AGREEMENT

The following information must be returned with the warranty request on all A/C compressors.

1. A copy of the original repair order.
2. A copy of the Paragon Products invoice the unit was purchased on.
3. A copy of the parts supplier invoice for the receiver drier, expansion valve, orifice tube (if equipped), A/C system flush, A/C hose assemblies (if applicable) and any other components replaced when the compressor was installed.
4. A copy of the second (replacement) work order.
The paperwork must be placed in the box and returned with the part.


Failure to follow these 12 steps when installing the compressor will void your warranty.

1. MUST clean A/C system with an approved flush, using an approved flushing method (R141b and Dura Flush are approved).  If an approved flush is not available, an in line filter MUST be installed per the installation instructions included with the compressor.
2. MUST replace filter drier or accumulator.
3. MUST replace orifice tube or liquid line that contains orifice tube (if applicable).
4. Inspect/replace thermostatic expansion valve & clean inlet screen (if applicable).
5. Check for proper air flow through cooling fins of condenser & radiator (condenser may need to be replaced, see additional information in the instructions included with the compressor).
6. Check for proper fan clutch or electric fan operation.
7. Check compressor clutch air gap before installation (refer to OEM or compressor manufacturer’s specifications).
8. MUST add correct type & amount of refrigerant oil (refer to OEM or compressor manufacturer’s specifications).
9. After hose assemblies are attached, turn compressor shaft (not just the clutch pulley) a minimum of 10 times to clear oil from compressor (a spanner wrench may be required).
10. Check compressor clutch electrical circuit for proper voltage (use either OEM or compressor manufacturer’s specifications).
11. Use only R12 or R134a refrigerant.
12. Evacuate entire A/C system for a minimum of 45 minutes if the temperature is above 80 degrees (60 minutes for dual air system or temperature is below 80 degrees.

MOST REMANUFACTURERED COMPRESSORS DO NOT CONTAIN OIL.  SOME NEW UNITS DO CONTAIN OIL.  You MUST add oil per OEM or compressor manufacturer’s recommendations.