Adjustable Ride Height Kit - Paragon
Items Included:
2x - Upper Spring Perch
2x - Koni Competition Bump Rubber
2x - Suspension Spring
2x - Aluminum Threaded Collar
2x - Lower Spring Perch
2x - O-ring |
Alternator Replacement Author: Skip
The alternator is located in the driver's side engine compartment, under the air-flow meter (AFM), in front of the Turbo unit, and on top of the A/C compressor looking down into |
Brey-Krause Strut Brace Installation - 944 Author: Skip
Installation :
Open hood to gain access to the strut bearing mounting nuts.
There are (4) 13mm. strut bearing mounting nuts per side. Remove the (2) front and (1) inner |
Clutch Replacement - Part One Author: Skip
The following account explains in detail the procedure of changing a clutch in a 944/951. It also contains a list of tools, chemicals, parts and the sources where to find them. The |
Clutch Replacement - Part Two Author: Skip
TRANSMISSION:
Remove shift boot lever (retaining clip at top )(Be careful of plastic cosmetic items, remove ashtray, two screws, lift center piece slightly & push out lea |
Control Arm, Front - Info Author: Skip
924 mid 82 and older - stamped steel - VW/Audi part# 477.407.153F (left & right)
924 mid 82 and later, 924S, 944 83-85.1 - stamped steel - VW/Audi part# 171.407.153D &nbs |
Porsche Option Codes Author: Skip
Code
Description
009
3 speed sportomatic transmission
018
Sport steering wheel with elevated hub
020
Speedometer with 2 scales KP |
Ask Dr. Koni Author: Skip
Question: What's the difference between the red Koni and the Sport Yellow Koni?
Answer: The valving is different. Sport Yellow units have stiffer valving than their St |
Engine Production Author: Skip
Engine : (USA values - to locate the "code", look for another Tech-Session article regarding Engine Identification )
944 - 8 Valve, Normally Aspirated
MY
Co |
KLA Strut Brace Installation - 924S, 944, 968
944 STRUT BRACE INSTALL
1) Remove 4 nuts holding strut
assembly to the body.
2) Place bracket over studs with
bracket upright toward front of car.
|
Koni Strut Conversion - 8641-1414S for late 944, 968 Author: Skip
Koni sealed strut insert conversion (8641-1414S)
Description
Image
Parts : Koni 8641-1414S Sport Struts - all conversion and instructions parts included.
|
Odometer Gear Replacement - late 944 Author: Skip
Instructions :
Remove 9 screws holding front/back together:
Remove 4 screws holding speedometer in housing:
Gently pull off speedometer needle and remove 2 screws holdi |
Oil Cooling, Auxiliary
KISS ENGINEERING OIL COOLER KITS
944/944 TURBO
TEST DATA AND INFORMATION
COOLER &n |
Porsche Chronology Some model history that may help with shopping our site
Model
Year
Engine
Note
356
55-65
911
  |
Rear Wheel Bearing Replacement - late 944, 968
Discussion :
This procedure will describe the removal and subsequent installation of rear wheel bearings on a Porsche 944 with aluminum trailing arms (1985.5 & later) |
Rod Bearing Replacement
Discussion:
This procedure will detail the steps necessary to replace the Rod Bearings on a 944 Turbo car. With some modifications it may also be applied to normally aspirated 944 |
Short Shift Kit
Procedure :
Raise care on lift or place on jack stands. Make sure car is safely and securely supported, and you have plenty of room to see around the transaxle.
Locate the |
Throttle Position Sensor Find the Throttle Position Sensor You Need Right Here.
Discussion:
The Throttle Position Sensor (TPS) is used to report various throttle positions to the DME. A very common failure item on t |
Koni Strut Conversion - 8641-1414S Koni Strut Conversion - 8641-1414S This procedure applies to the following Porsche models: 1987-89 944 1987-88 944S 1989-91 944S2 1986-88 944 Turbo 1992-95 968 |
Porsche Reference Material Author: Skip
Click the "buy now" links to visit the Paragon Bookstore
Parts and Tech Ref Catalogs:
Genuine Porsche Parts
Catalog CD
buy now
|